Queclink GV200 Spécifications télécharger pdf (Page 71)

GV200 @Track Air Interface Protocol

TRACGV200AN003 – 70 –

3.2.23. Excessive Idling Detection

The command AT+GTIDL is used to detect the engine excessive idling (stationary while ignition

on). To use this command, the ignition signal must be connected to the device. When the device

detects that the vehicle is entering into the idle status, it will report event message

+RESP:GTIDN to the backend server. When the vehicle leaves the idle status, the device will

report event message +RESP:GTIDF to the backend server.

 AT+GTIDL=

Example:

AT+GTIDL=gv200,1,2,1,,,,,1,1,0,0,,,,,0015$

Parameter

Length(byte)

Range/Format

Default

Password 4 – 6 '0' – '9' 'a' – 'z' 'A' – 'Z' gv200

Mode 1 0|1 0

Time to Stationary <=2 1 – 30min 2

Time to Movement 1 1 – 5 min 1

Reserved 0

Output ID 1 0 – 4 0

Output Status 1 0|1 0

Duration <=3 0 – 255(×100ms) 0

Toggle Times <=3 0 – 255 0

Reserved 0

Serial Number 4 0000 – FFFF

Tail Character 1 $ $

 <Mode>: Working mode.

 0: Disable this function

 1: Enable this function.

 <Time to Stationary>: If the vehicle is detected to be stationary with ignition on for this time

Queclink

Confidential

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 258 259

Pas de commentaire

Queclink GV200 Spécifications Page 71